The ioLogik E4200 is suitable for remote monitoring and alarm
systems, such as are used for water treatment systems, water supply
systems, wastewater treatment systems, and power monitoring systems.
These kinds of applications need more I/O points and a variety of I/O
types, including temperature sensors, gas detectors, and water quality
detectors, all of which can benefit from the versatile mixture of I/O
features supported by the ioLogik E4200.
Slice Form Factor and Flexible I/O Combination
The unique modular construction of the ioLogik E4200 allows the
mixing and matching of modules to achieve the best combination of I/O
modules to meet the needs of a wide range of remote automation
applications. The ioLogik E4200 features an industrial modular housing
that allows up to 16 I/O modules to be added to the base unit without a
backplane. The width of each module is merely 12 mm, and at a full load
of 16 modules, the total size is less than 25 cm—perfect for
space-limited applications. The ioLogik E4200 provides up to 256 DI/DO
points or 64 AI/AO points for greater flexibility and expandability. The
modules can connect to virtually any type of sensor, including but not
limited to those for temperature, pressure, flow, voltage, current, and
contact closure.
Two Independent Ethernet LANs
ioLogik E4200 modular remote I/O comes with dual network interfaces
with separate MAC and IP addresses for connecting to different network
segments. The two independent Ethernet LANs improve system reliability
by allowing hosts located on different networks to control and monitor
the remote I/O units.
Click&Go™ Code-free Local Intelligent Control
The patented Click&Go
event-based control logic offers local control without the need to
communicate with the remote host. Click&Go’s intuitive, graphical
interface and simple IF-THEN-ELSE control logic, which defines how the
ioLogik E4200 will respond to different events, is easy and
straightforward to set up. Click&Go supports active communication
methods, including TCP, UDP, SNMP Trap, email, and CGI commands, making
it extremely easy to integrate Click&Go with any monitoring system.
